Most panels in bars can be installed by two people with basic tools. Download the installation guide PDF for diagrams.
Tools
- Drill/driver and bits
- Level (a laser level speeds up groupings)
- Tape measure and pencil
- Wall anchors suited to the wall type
- A ladder or lift for ceiling products
Wall panels with Z-clips
- Mark the top edge of each panel using the paper template.
- Fix the wall half of each Z-clip level, into studs or with anchors.
- The panel half is factory-fitted to the back of the panel.
- Lift the panel over the wall clips and slide it down until it locks.
Ceiling products
- Locate structure above (joists, deck or purlins).
- Fix the ceiling anchors for each cable.
- Hang the cables, attach the grippers and set the height.
- Level the product by adjusting each gripper.
For wall-specific fixings see mounting on concrete and mounting on drywall.